Christmas tealight

Product Description

Features: Standard CR2032 Battery (Clip in) 5mm LED Easy Solder Ideal light source for your projects Optional Switch Text for lead identification of LED

Additional Notes

Hats: Hats can be placed on top of the tea light with a push fit, here are some suggestions: Candle TeaLiight Hat: http://www.thingiverse.com/thing:1188098 Christmas Tree Hat: http://www.thingiverse.com/thing:193814 (Diameter: 42; Height: 14.65; LED Holder Outer Diameter: 9.8) Snowman Hat: http://www.thingiverse.com/thing:1188099 Parts: Battery Holder: https://solarbotics.com/product/bhold2032/ or http://www.digikey.com/product-detail/en/BS-7/BS-7-ND/389447 LED: Any 5mm LED that has a 3 Volt forward voltage or less will do, here are some animated suggestions: https://www.sparkfun.com/products/11450 (slow color cycle) https://www.adafruit.com/products/679 (slow color cycle) http://shop.evilmadscientist.com/productsmenu/partsmenu/353 (candle flicker) Switch (Optional): The battery holder can be used as a switch by using the built in clip, but if a switch is desired: http://www.digikey.com/product-search/en?keywords=CKN10397 DISCLAIMER: Use at your own risk. Print Settings Printer brand: MakerBot Printer: MakerBot Replicator 1 Rafts: Doesn't Matter Supports: Yes Resolution: 0.27mm Infill: 0% Notes: Print with exterior support, 0% infill and 0 shells. Larger sizes may require 5% infill. Post-Printing Insert battery holder, aligning pins through holes Note which LED lead is the longest, this is the positive lead and needs to connect to the positive terminal on the battery holder (the clip) Bend LED leads at 90 degrees close to the base Insert LED in holder Insert switch in holder if using (clips in, can tack with hot glue if necessary) Bend LED leads around battery holder pins (If using switch, connect one lead to switch center, and use a piece of wire to connect from switch outer to battery terminal) Solder leads to pins Insert battery and test